2. Turn bulb holder approx. 3/8" (1 cm) counterclockwise and remove it.
3. Depress bulb in bulb holder, turn it slightly counterclockwise, and remove it.
4. Install a new bulb. Install bulb holder in tail lamp. NOTE: One of the bulb holder tabs is wider and
fits in corresponding recess only.
5. Turn bulb holder clockwise. Check that bulb lights. Replace tail lamp inside cover.
Bulbs
Power
CP(W)
Socket US Bulb No
1 Reflector - - -
2 Back up light 32(21) Ba 15s 1073
3 Rear turn signal 32(21) Ba 15s 1073
4 Rear fog lamp 32(21) Ba 15s 1073
5 Tail light 4(5) Ba 15s 67
6 Tail light/brake light* 32/3(21/5) BAY 15d 1157
*For high-mounted brake light specification, see "specifications" section.
pg. 76 Replacing bulbs
Replacing tail light bulbs (wagon models)
● Turn off the lights
● Remove the cover with a screw driver
● Rotate the bulb holder about 1/2" (1 cm) counterclockwise and remove the holder from the tail light
cluster.
● Gently press the bulb into the holder, then rotate the bulb counterclockwise in order to release it.
● Install a new bulb in the holder and replace the bulb holder in the tail light cluster.
To Next Page
Loading...
