Volvo 850 User Manual

1996 Volvo 850
pg. 6:3 Wheel changing
There is a jack attachment located in the center on each side of the car. Position the jack on the bar in the
jack attachment as shown in illustration A above and crank while simultaneously guiding the base of the
jack to the ground. The base of the jack must be flat on a level, firm, non-slippery surface. Before raising
the car check that the jack is still correctly positioned in the attachment . Raise the vehicle until both
wheels on the side of the car where the jack is attached are lifted off the ground. Unscrew the wheel
bolts completely and carefully remove the wheel so as not to damage the tread of the studs.
Jack attachment
file:///K|/ownersdocs/1996/1996_850/96850_601.htm (3 of 5)12/30/2006 9:59:39 AM

Volvo 850 Specifications

Torque Specifications

ABS Sensor Torque	7 ft. lbs. (10 N.m)
Bearing Cap Torque	18 ft. lbs. (25 N.m)
Lug Nuts Torque	81 ft. lbs. (110 N.m)
Suspension Arm Nuts Torque	13 ft. lbs. (18 N.m)
Suspension Arm To Anti-Roll Bar Torque	37 ft. lbs. (50 N.m)
Suspension Arm To Anti-Roll Bar Center Nut Torque	80 ft. lbs. (120 N.m)