To enter the code
When the set has been disconnected from power the set displays "cod" after being switched on. the "cd"
indicator lamp (13) flashes. Enter the 6-digit code using the preset buttons (10). Please note that only 4
digits will be seen in the display. Press the "aut" button (9). Do not press "aut" until you have entered the
correct code. If the correct code is entered "on" is displayed and the set is now ready for use. If you enter
an incorrect code you must enter the correct code from the beginning again.
Incorrect code
If an incorrect code is entered "rpE" is displayed. Enter the correct code.
Once you have attempted to enter an incorrect code three times the set will lock and remains locked for
1 hour.
"OFF" is displayed.
The unit must be connected and turned on during this time.
Enter the code again once this time has elapsed.
pg. 1:19 Radio
file:///K|/ownersdocs/1993/1993_940/93940_1_17.html (3 of 12)12/30/2006 9:44:19 AM
To Next Page
Loading...
