Volvo D20 - Page 61

Group 21 Reconditioning engine
Assembly
J. Assembly
,,,.,
•••
TIMINGGEAR
Jl
Install
- cover plate. Do not tighten coolant pump mounting
balts fully at this stage
- fan/alternator
mounting braeket
-
idler pulley. Tap pulley into position and install cen-
ler balt
- crankshaft gear.
J2
Install camshaft front spracket and gear belt
Ensure that bel t sits correclly on all gears. Tighten
center
bolt by hand, it should be possible to turn
sprocket on camshaft.
J3
Install lower timing gear caver and vibration
dampar
Damper can only be fitted in one way. Pin on
crankshaft
must fil in vibration damper.
Torque inhex
balts to 20 Nm (15 f t Ibs).
59