If the machine is laid up for a longer period, the tank ought to be
completely full with fuel to prevent corrosion of the insides of the
tank.
Fuel filling can also be done with an electrical pump under the
step close to the fuel tank, which is provided with an electronic
overfilling protection. The inlet side of the pump is connected to
a suction pipe via a hose. At the outer end of the pipe there is an
inlet strainer.
1 Fold down the cover under the step.
2 Put the hose in the fuel barrel.
3 Start the pump by pressing green button (B). When the tank
is full, the pump stops automatically.
4 If you would like to interrupt the filling, press red button (C).
5 When filling is done with the manual filling button (D) the button
must be pressed the whole time. The pump will stop when
releasing the button.