Figure 3
Use the seat belt during all operation
If the seatbelt needs washing: Use a mild soap solution when washing and let the belt dry while it's fully pulled out
before it's rolled up. Make sure that the belt is installed correctly.
Replace the seatbelt immediately if it's worn, damaged or the machine has been involved in an accident where the
belt had to take some strain.
Modifications of the belt or its mountings is never permitted.
The hip-type seatbelt is intended for one adult, not more.
Always keep the belt rolled up when not in use.
When the engine is running
Respect the warning lights. The red lights require immediate attention or consideration, see instructions in the
Operator's manual in the section Instruments.
Apply the parking brake and make sure that the attachment/attachment bracket rests on the ground.
Move the gear selector to neutral before you leave the machine.
WARNING
Risk of crushing injuries
Do not stand near the frame joint unless it has been locked with the frame joint lock.
Empty and tilt back the attachment before operating the machine on a road.
Stop the engine and lower the attachment so that it rests on the ground before you leave the machine unattended.
When there is a risk of roll-over
The cab is the operator's protection and meets the standards for roll-over protection according to test standards, (ROPS),
see further Prerequisite for protection is that the operator uses the lap-type seat belt and
191 CE-marking, EMC-directive
remains in the cab in case of a roll-over. Therefore, hold on to the steering wheel if the machine rolls over. Do not jump!
Falling objects
The cab is dimensioned to fulfill the requirements for objects falling on to the cab roof according to given test methods (that
is, FOPS, see further
191 CE-marking, EMC-directive
Emergency exits from cab
The cab has two emergency exits, the door and the right side window.
Actions before recovering and towing
See Section 1, Towing
Actions after recovering and towing
WARNING
Do not forget to unlock the frame joint lock and secure it in the running position when the machine is to be
operated again.
See Section 1, Service and Maintenance
To Next Page
Loading...
