Service Information
Document Title: Function Group: Information Type: Date:
Safety rules when servicing 191 Service Information 2014/5/8 0
Profile:
WLO, L110E [GB]
Safety rules when servicing
This section covers general safety rules when checking and servicing.
Other rules, information and warning texts are given in the Operator's manual.
CE marking
This machine is CE-marked. This means that, when delivered, the machine meets the applicable "Essential Health and Safety
Requirements", which are given in the EU Machine Safety Directive. If changes are made that affect the safety of the
machine, the person making the changes is responsible for the same.
Therefore, the following applies:
Install communication equipment (two-way radio), mobile phone unit, etc. according to the manufacturer's
instructions in order to eliminate interference with electronic systems and components intended for the machine's
function. See further .
191 CE-marking, EMC-directive
When retro-fitting equipment in or on the cab; do not drill, weld or cut in the cab structure since such actions may
impair the operator's protection in case of roll-over. See further .
191 CE-marking, EMC-directive
Before you begin any service work:
Service work done incorrectly is dangerous.
Make sure that you have sufficient knowledge, correct information, the right tools and the correct equipment to perform the
service in a correct manner.
Repair or replace damaged tools and defective equipment.
Park the machine on a level and hard surface and prepare it for service by placing it in the service position according to
figure:
Service position
Figure 1
Service position
1.
2.
Attachment resting on the ground.
Parking brake applied.
To Next Page
Loading...
