3.
4.
5.
6.
7.
8.
Engine off and ignition key removed. (Does not apply for special checks).
Pressurized lines and pressure tanks shall be depressurized carefully so that the high pressure is released without
risk. [ 1]
191 Safety when working on hydraulic systems
Yellow-black warning flag should be attached to the steering wheel (USA - a red flag may be used instead)
Frame joint lock connected.
Wheels blocked with wedges or similar.
Allow the machine to cool down. [ 2]
NOTICE
When lifting the machine, the frame joint should be locked and the marked eyes intended for lifting should be used.
NOTE!
No work may be done on the machine until you have the correct skills and knowledge of the machine to do the work.
Figure 2
Read the Operator's Manual, plates and instructions before you operate the machine.
General
Machine working in a environmentally contaminated area, see
191 Working in environmentally contaminated areas
See also .
191 Checklist after a fire or heat exposure
If someone is to take over the job that you have started, make sure that this person is informed about what part of
the work has been completed and what remains to be done.
When high-pressure washing the machine, do not aim the water jet directly at anti-slip surfaces or decals that are
glued on.
WARNING
Only walk or step on the machine's prepared stepping surfaces, see operator's manual.
Figure 3
Do not step on engine covers.
To Next Page
Loading...
