Vonets VAP11G-300 Quick Setting Guide

VONETS WiFi Bridge/Repeater
4
Setting Guide
1. Connect Device
VONETS device is powered on (5V/2A) and then connected to the computer. There are two ways to
do this:
1) The computer is wired connected to the LAN port of VONETS device;
2) The computer is connected to WiFi signal of VONETS device, its hotspot parameters
as below:
WiFi SSID: VONETS_******
（
Corresponds to the MAC address of the VONETS device
）
WiFi password: 12345678

Vonets VAP11G-300 Specifications

General

Wi-Fi Standard	802.11b/g/n
Frequency	2.4GHz
Max Data Rate	300Mbps
Weight	30g
Storage Temperature	-20°C to 70°C
Antenna	Built-in
Operating Mode	AP, Repeater
Ethernet Port	10/100Mbps
Operating Humidity	10% to 90% (non-condensing)
Storage Humidity	5% to 95% (non-condensing)
Port	RJ45