VooPoo VMATE - Coil Management and Function Tips; Temperature Control Coil Type Management; Functionality Tips

before sleeping mode, screen will display
the prompt “NEW Coil YES/NO” on
interface; Press the fire buon to recover
display form sleep mode.
I. Computer customizaon：
You can do the following customizaon
operaons via the voopoo Firmware: Prompt
page, Temperature coefficient, temperature
curve, waage curve, increase/increase coil
type and device upgrade etc.
J. When the device is connected to an
external power supply (5V) using the USB
charging port, it will enter charging mode.
Charging mode of the first 10s, the baery
small icon will run as the baery charging
which shows that charging began. With
10s without any operaon, the device will
enter power saving mode, and the
full-screen will display baery power as a
large icon running. When the power is full,
the icon will be seen as below.
K. Adding, removing or changing
temperature control coil types using the
Voopoo Firmware.
(Default: SS316,Ni200,TI) You can select 1
to 5 types. Coil coefficient seng and
selecng Serial coil mark coefficient select
L. Funcon ps:
TIME OUT COIL NO(-)
NEW YES(+) LOW POWER
Index Type Icon Coefficient Select
1 SS316 SS
1300
2 Ni200 Ni
6500
3 Ti Ti
4000
4 NC NC
400
5 TCR TC
1000
9