Vornado EVAP3 - Cleaning and Disinfection; Cleaning the Base and Tank

13
English
CLEANING
Proper cleaning of your Evaporative Whole Room Humidier is essential to the air quality and performance of your humidier. The frequency in
which your humidier will need to be cleaned will vary depending on use, water hardness and outside environmental factors. It is recommended,
assuming average use, to thoroughly clean the unit several times throughout the season, or when algae, mineral deposits or other particles
begin to form.
TO CLEAN AND DISINFECT BASE
1. Turn humidier Off and unplug.
Warning: Do not submerge humidier in water.
2. Remove Power Head and Wicks.
3. Remove Water Tank and Inlet Grill. To remove Inlet Grill, undo
the latch (E) and lift Inlet Grill up (F). Empty Base and Water Tank,
then rinse with clean tap water.
4. Mix solution of 1 teaspoon chlorine bleach and 1 gallon water.
Fill Base with solution, wet all surfaces and discard unused
solution. Let stand 20 minutes.
5. Empty and rinse with water until bleach smell is gone. Dry with
clean cloth or paper towel.
+
1 gal.
Water
1 tsp.
Chlorine
Bleach
20 min
E F