EasyManua.ls Logo

Vornado iControl - User Manual

Vornado iControl
12 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
model iControl
READ AND SAVE THESE INSTRUCTIONS
Whole Room Heater Owner’s Guide
LEER Y GUARDAR ESTAS INSTRUCCIONES
Guía del propietario el calentador para ambientes
www.vornado.com

Table of Contents

Other manuals for Vornado iControl

Preview: Guide De L'Utilisateur
Guide De L'Utilisateur8 pages

Questions and Answers

  • S
    Sarah FischerAug 10, 2025
    What to do if my Vornado iControl Heater fails to power on?
    • R
      Robert RobertsAug 10, 2025
      First, make sure the power cord is properly plugged into an electrical outlet. If it still doesn't turn on, check your household circuit breaker or ground fault interrupter and reset it, or replace the fuse if necessary. Overheating can also cause this issue, so allow the Automatic Safety Shut-Off to reset. If none of these steps work and you suspect damage, stop using the heater, unplug it, and contact Consumer Service for assistance.
  • S
    Sara AtkinsAug 20, 2025
    Why is my Vornado iControl not producing enough heat?
    • A
      Alexis SawyerAug 20, 2025
      Ensure that your Vornado Heater is set to High Heat and the thermostat is at the highest temperature. Close all doors and windows in the room to keep the heat in. It may take several minutes for the unit to fully circulate the heat throughout the room.
  • J
    Jesus VillaAug 30, 2025
    What to do if my Vornado iControl Heater power on but there is no heat?
    • M
      mollygomezAug 30, 2025
      If your Vornado Heater powers on but isn't producing heat, power it off and unplug it. Locate the black disk on the bottom of the unit and push it in 4-5 times to ensure it's not stuck. Place the unit on a flat surface, making sure the power cord is not underneath it. Plug the unit back in, power it on, and set it to the highest heat setting.

Summary

Important Instructions

Controls

Power On;Off

Controls the power supply to the unit.

Mode

Selects between High Heat, Low Heat, or Fan Only.

Temperature

Adjusts the desired comfort level using UP/DOWN arrows.

Timer

How To Use

Getting Started

Basic steps for initial setup and operation.

One-Knob Operation

Remote Control

Resetting Your Vornado Heater

Procedure to reset the safety shut-off system.

Advanced Safety Features

Automatic Safety Shut Off System

Shuts off power to heating element and fan during overheating.

Tip-Over Switch Protection

Shuts down heat and fan functions if the unit tips over.

Operating Tips

Circuit Breaker Issues

Multiple Heater Warning

Electrical Problem Indicators

Troubleshooting

Unit fails to power on

Possible causes and solutions for no power.

Unit not producing sufficient heat

Causes and solutions for insufficient heat output.

Unit power on but no heat

Solutions for when the unit is on but not heating.

Vornado iControl Specifications

General IconGeneral
BrandVornado
ModeliControl
CategoryHeater
LanguageEnglish

Related product manuals