Appendix B: The Wizard - What else does it setup?
On startup the wizard will reset Betaflight configuration to its default state.
Once completed the following features, configurations and mode will be injected in Betaflight so you can start to
enjoy your Vortex straight off the box with zero additional configuration needed:
Enabled, Throttle set to 1100
PPM Sum Mode (all channels down a single cable)
According to Wizard prompts
Default ImmersionRC settings (based on UmmaGawd’s tune)
NOTE: If you have ‘tweaked’ any Betaflight settings outside of the Vortex OSD, please remember to back
them up before running the wizard the next time, since it will reset them to default settings.
Appendix C: Video Tx - Staying Legal
Depending upon the Vortex variant purchased, and the Tx module installed, the video transmitter power output
level, and available transmit frequencies can vary.
It is highly recommended to understand the rules and regulations in your country before using the Vortex.
Transmitting outside a legal band is something frowned upon by the authorities, and may result in a fine, or
confiscation of equipment.
As a rule of thumb, the following charts should help understand which frequencies are legal in each of our main
markets.
To Next Page
Loading...
General