Need help?Do you have a question about the Vortex 150 MINI and is the answer not in the manual?
General| Wheelbase | 150mm |
|---|---|
| Battery | 3S 1300mAh LiPo |
| Flight Time | 5-7 minutes |
| Controller Frequency | 2.4GHz |
| LED Lights | Yes |
| Flight Controller | F3 |
| ESCs | 20A |
| FPV Transmitter | 25mW |
| FPV Camera | 600TVL |
| Camera | 600TVL CCD |
Covers warnings about avoiding obstacles, learning Acro mode, and general safety.
Highlights dangers of propellers and the necessity of installing the antenna before powering up.
Recommends using the 'Liftoff' simulator for practicing flight skills and familiarization.
Points to a separate guide for initial setup, including battery and receiver selection.
Details the USB connector for configuration and the reset button's multiple uses.
Describes the Synergy button for firmware updates and the universal receiver connector.
Guidance on routing antennas through slots to ensure optimal signal range.
Crucial warnings on polarity and handling of the XT-30 connector to prevent damage.
Reference for part numbers of connectors and wires for repairs or upgrades.
Instructions for assembling arms and mounting the flight camera.
Details camera tilt adjustment and control via the OSD.
Explanation of the Lost Model Alarm triggered by disarming or failsafe.
How to use the TNR tag to set video transmission frequency before powering up.
Information displayed on the welcome screen, including FC and API versions.
Instructions on entering the main menu and navigating its pages.
Configuring display landscape, quad naming, and battery capacity for warnings.
Enabling/disabling alarms for battery status, UHF, and flight time.
Settings for LED mode and parameter mode (intensity, frequency, gradient).
Allows tuning of parameters like PIDs and enabling Air Mode without a laptop.
Accessing and adjusting PID settings for flight control.
Configuration of RC rates, expo, and throttle expo for flight control response.
Graphical view of the 5.8GHz band, detailing supported frequency bands.
Settings for video transmitter channels, bands, and power output.
How to access and use the camera's OSD for tuning settings.
Methods to configure the video transmitter: OSD Menu, TNR Wand, and PitStick Mode.
Using DSMX mode with compatible Spektrum radios for vTx control.
Illustrates stick assignments for different transmitter control modes.
Detailed explanations of Acro, Angle, and Horiz flight modes and their characteristics.
Steps for connecting to the Vortex using the Betaflight Configurator via USB.
Commands for entering menu, disarming, arming, and resetting vTx channel.
Details the 16A ESC features, including the RotorSENSE motor direction programming.
How to choose and apply pre-configured pilot tunes for optimal flight characteristics.
Details receiver interface cables and lists recommended receivers for internal mounting.
Tips for selecting receivers to minimize latency for racing.
Explains receiver auto-detection by the OSD and transmitter configuration wizard.
Provides rules for safe and courteous flying with other pilots.
Introduction to the motor test for diagnosing issues, with critical safety warnings.
Steps to start the motor test, use controls, and the warning about props spinning.
How to analyze test results for individual motors and all motors combined.
Suggestions for motor upgrades and advice on what to avoid.
Steps for preparing for firmware upgrades, including drivers and software.
Detailed procedures for standard firmware upgrades and recovering a bricked OSD.
Guide for upgrading the flight controller firmware using the Vortex Configurator.
Overview of default settings applied by the wizard upon startup.
Information on legal requirements for video transmitter power and frequencies.
Details legal frequencies and bands for the Americas region with a Ham license.
Legal frequencies and bands for Europe without a license (25mW Tx).
Legal frequencies and bands for Europe with a Ham license, varying by country.
Explanation of LED board indicators for sensor status and compatibility.
Steps to take if the Vortex gets wet, including rinsing and drying methods.
Advice on avoiding sun damage to camera/LiPos and cleaning dirt with a toothbrush.
Details specifications for FC, OSD, and integrated Video Transmitter features.
Information on prop size, stock motors, and recommended battery specifications.
Details ESC type, receiver requirements, and camera video standards.
Specifications for weight, size, flight time, and maximum speed.
List of part numbers for spare parts and upgrade kits.
Guidance on obtaining support through resellers, online forums, and repair centers.
Addresses ESC calibration (not needed) and flying in rain.
Procedures for water damage recovery and troubleshooting motor stuttering.
Troubleshooting receiver auto-detection failures and camera-related problems.
Troubleshooting startup beeps, ground view, flips, and Betaflight tuning after updates.
Information on RF regulations, power limits, and USA drone registration requirements.
Advocates for safe operation, equipment checks, and responsible flying practices.
Guidance on handling warranty claims and repairs through the original retailer.
Provides links to ImmersionRC's social media channels for updates and community engagement.
To Next Page