Vortex Viper HD 3000 - Power Up

VIPER
®
HD 3000
8 9
MODE SELECTION
Changing Modes on the Viper
®
HD 3000
The Viper
®
HD 3000 is factory set to the angle
compensating HCD range mode, Normal target mode,
brightness level 3, default auto-shutoff at 30 seconds,
and displayed in yards.
To Change Modes
Press and release the
“Measure” button to power
the unit On. To change
modes, press and hold the
“Menu” button until the
Mode Selection screen
appears (about 2 seconds).
Scroll through the mode
options by clicking
the “Menu” button. To
adjust a mode, click the
“Measure” button.
To save your settings and exit the Mode Selection screen,
press and hold the “Menu” button for at least two seconds.
Use the “Menu”
button to activate
the Mode
Selection menu
and scroll through
mode options.
Use the “Measure”
button to adjust
the mode.
RANGING MODE SELECTION
Choose Between the HCD and LOS modes
After activating the Mode/Display Selection, press the
“Measure” button to toggle between the HCD and LOS
displays. Press the “Menu” button to save your desired
choice and move to the Yards/Meters selection screen.
LOS ModeHCD Mode