VOX electronics PIO 650 2MW User Manual

16
5
On-Off: The appliance will start once this
button is pressed.
Decreasing Speed: Speed will decrease if
this button is pressed.
Increasing Speed: Speed will increase if
this button is pressed.
Timer: When the button is pushed on, a
timing function is activated for a period of
15 minutes, and once the timing starts,
also the display gives a signal, and the
motor stops automatically after 15 min-
utes.
Lamp: The lamp will turn on once the but-
ton is pressed. Re-press the button to turn
off the lamp.
Cleaning Periods of the Filters:
The lters must be cleaned when " " signal ap-
pears on the display or (depending on usage)
after every 2-3 weeks. When the lters are
cleaned and mounted in their places, press but-
ton for more than 3 seconds in order to delete
" " signal (when the product is inactive) .Letter
"E" will appear on the display, and the prod-
uct will switch to normal operation. If the op-
eration is desired to continue without deleting
" " signal, when you push on ( ) button, active
operation will be observed for 1 sec. and then
"C" signal will reappear and the motor will con-
tinue to run.
NOTE: “ ” mark will appear at the end of the
product's usage period of 60 hours.
E󰀩cient Use With Regard to Energy
Saving:
* When using your hood, adjust the speed set-
tings according to vapour and odour intensity, in
order to save energy.
* Use low speeds (1-2) under normal conditions,
and high speeds (3) in intense odour and vapour.
* The lamps on the hood are placed for illuminat-
ing the cooking area.
Using them for environmental lighting shall
cause unnecessary energy expenditure and in-
sufcient lighting.
Use of Hood:
* Your hood contains a motor that has various
speeds.
5 Spd Dgt Switch
A ATTENTION
"C" mark will appear at the end of the product's
usage period of 60 hours.

VOX electronics PIO 650 2MW Specifications

General

Brand	VOX electronics
Model	PIO 650 2MW
Category	Ventilation Hood
Language	English