8 APS787Z Owners REV.B
To Enter & Exit the Vehicle while (Manual Transmission) Remote Start
Ready Mode is already active without cancelling Remote Start Ready
Mode.
If ready mode has already been activated and you need to enter the vehicle,
possibly to retrieve an item, and will exit the vehicle without driving it, you
can keep ready mode active by following the steps below.
1. With Ready Mode already previously set, activate the remote start.
2. While under control of the remote start open vehicle door to retrieve
items.
3. Exit the vehicle and close all doors.
4. Press the
button.
The unit waits three (3) seconds and then shuts down, the system will verify
all doors have been closed then will emit the two (2) short / one (1) long chirp
and light ash pattern indicating Manual Transmission Ready Mode is active.
Note: If the two (2) short / one (1) long chirp is not heard then Ready Mode
has not been set.
Remote Start Ready Mode - Manual Transmission Vehicles Only
To activate the remote start function, the system must rst be in Remote Start
Ready Mode. Follow the steps below to enter remote start ready mode.
• While the engine is running by the ignition key;
1. Place the transmission in neutral.
2. Set the parking brake.
• With your foot o the brake pedal;
1. Press and release the
button to activate the remote start.
The parking lights will turn on to conrm the system has
remote started.
2. Remove the keys from the ignition, the vehicle will remain
running.
3. Exit the vehicle and close all vehicle doors.
4. Within two (2) minutes of step 1, press the button to lock the
vehicle’s doors.
The vehicle will shutdown and sound two (2) short chirps then one (1) long
chirp to conrm ready mode is set.
Remote Start Ready Mode must be enabled if your vehicle is equipped
with a manual transmission.
To Next Page
Loading...
