Dial type
If you have touch-tone service, your telephone is ready to use as soon as the battery is charged. If
you have pulse (rotary) service, the dial type must be changed. To change the dial type, refer to the
Dial type section on page 12.
Installation
Desk/table bracket installation
To place the telephone base on a desk or table, insert the desk/table bracket as shown below.
• Position the bracket on the bottom of the telephone base and slide it up towards the tabs on the
telephone base until it clicks into place.
• Remove the bracket by pulling the bracket down with both hands away from the telephone base.
To Next Page
Loading...
Need help?
General
