Appendix
Expand your telephone system
The handsets provided with your telephone system are already registered.
Each handset is assigned a number that displays on the handset. Additional
handsets registered to the telephone system are assigned in sequential
order. For instance, if the telephone system already has HANDSET 1 and
HANDSET 2, the new registered handset is assigned HANDSET 3. This
telephone system accommodates up to ve handsets.
Add and register a handset (optional)
You can add new handsets (LS6305, purchased separately) to your
telephone system. Each handset must be registered with the telephone
base before use. When rst purchased, each handset shows
1.Press FIND
HS on base 4sec and 2.Then press # on handset
alternately. You may
need to charge the handset before registering it to the telephone base. For
more details on battery charging, see page 4.
To register a handset:
Place the unregistered handset in the telephone base or charger. If
1.Press FIND HS on base 4sec and 2.Then press # on handset do not
appear alternately on the handset screen after a few seconds, remove the
handset and place it in the telephone base or charger again.
On the telephone base, press and hold
/FIND HANDSET for about four seconds until the red
IN USE light on the telephone base turns on.
Remove the handset from the telephone base or
charger and then press # (pound key). It displays
Registering...Please wait. It takes about 10 seconds
to complete the registration. The handset shows
HANDSET X Registered and you hear a beep when
the registration completes.
1.
2.
3.
If the registration fails, the handset displays Registration
failed for a few seconds, then 1.Press FIND HS on
base 4sec and 2.Then press # on handset alternately.
To reset the handset, remove it from the telephone base
and place it back in. Try the registration process again.
You cannot register a handset if any other system
handset is in use.
•
•
53
To Next Page
Loading...
Need help?
General
