6
Getting started
Parent unit battery installation
To replace the battery, press down on the large tab of the battery and lift
it out of the battery compartment, then follow the steps on page 5 to install
the battery.
The operating time for using the rechargeable battery is short. If you want
to monitor your baby for a long time, we recommend you connect the
parent unit to AC power.
If the parent unit will not be used for a long time, disconnect and remove
the battery to prevent possible leakage.
Use only the battery supplied with this product. To purchase a replacement
battery, contact VTech on 1300 369 193.
•
•
•
To Next Page
Loading...
