4
Getting started
Baby unit installation
Install the baby unit as shown below.
Make sure that the power outlet is not controlled by a wall switch. Bundle the
power cord neatly with the self-adhesive strap.
Use only the baby unit power adapters supplied with this product. To order a
replacement, contact VTech on 1 300 369 193.
The baby unit power adapters are intended to be correctly oriented in a
vertical or oor mount position. The prongs are not designed to hold the plug
in place if it is plugged into a ceiling, under-the-table or cabinet outlet.
Make sure the baby units and the power adapter cords are out of reach
of children.
•
•
•
Power outlet not
controlled by a
wall switch
Baby unit
power adapter
Self-adhesive strap
Raise the antenna for
better reception.
Baby unit
To Next Page
Loading...
Need help?
General
