Status check - Two baby units
If you are viewing baby unit , the POWER LED light of baby unit turns on. As
baby unit is not being viewed, its POWER LED light flashes.
Notes:
• If you power on only one baby unit, you may see the parent unit displaying and
then , and the LINK LED light flashing.
• Press VIEW in Single CAM or Patrol mode to switch to the baby unit you have
powered on.
Monitoring Modes (BM4200N-2 only)
When more than one baby unit is paired to the parent unit, you can choose to view
different baby units in three monitoring modes. Learn more about each below:
Single Mode The screen displays images only from the selected
baby unit in full screen.
Split Mode
The screen displays images from all paired baby
units at the same time in split view.
Patrol Mode
The screen displays a single cam view that
transitions to a different baby unit every 10
seconds.
To Next Page
Loading...
Need help?
General
