7
• If you place the handset in the telephone
base or the charger without plugging in the
battery, the screen displays No battery.
Battery
indicators
Battery
status
Action
The screen
is blank, or
displays Put
in charger
and flashes.
The battery
has no or
very little
charge. The
handset
cannot be
used.
Charge
without
interruption
(at least 30
minutes).
The screen
displays
Low battery
and flashes.
The battery
has enough
charge to
be used for
a short time.
Charge
without
interruption
(about 30
minutes).
The screen
displays
HANDSET X.
The battery
is charged.
To keep
the battery
charged,
place it in the
telephone
base or
charger when
not in use.
When the battery is fully charged, you
can expect the following performance:
Operation
Operating
time
While in use (talking*) Seven hours
While in speakerphone
mode (talking*)
Three and a
half hours
While not in use (standby**) Five days
* Operating times vary depending on your
actual use and the age of the battery.
** Handset is not charging nor in use.
To manually set the date and time
and the answering system, refer to
Congure your telephone and Set
your built-in answering system
sections.
To manually initiate the voice guide, refer
to Voice guide under Set your built-in
answering system section.
Before use
After you install your telephone or power
returns following a power outage, the
handset will prompt you to set the date
and time, and the answering system
through voice guide.
Set date and time
• Make sure you set the date and time
including the year correctly; otherwise the
answering system does not announce the
correct day of the week for your recorded
messages time stamp.
1. Use the dialing keys (0-9) to enter
the month (MM), date (DD) and year
(YY). Then press SELECT.
2. Use the dialing keys (0-9) to enter
the hour (HH) and minute (MM).
Then press q or p to choose AM or
PM.
3. Press SELECT to save.
After the setting for the date and time,
the handset will display Voice guide to...
and set up Ans sys? alternatively.
Set answering system through
voice guide
This feature assists you to do the basic
setup of the answering system. You can
follow the voice guide to record your own
announcement, set the number of rings
and the message alert tone.
1. Press SELECT to start the voice
guide for the answering system
setup. You hear the voice prompt
“Hello! This voice guide will assist
you with the basic setup of your
answering system.”
2. Setup your answering system by
inputting the designated numbers as
instructed in the voice guide.
To Next Page
Need help?
General
