10
NOTES
• You cannot edit a directory entry while on
a call. Refer to the Directory section for
more details.
• You cannot copy a caller ID log entry into
the directory while on a call. Refer to the
Caller ID log section for more details.
• You cannot erase a redial entry while on
a call. Refer to the Redial list section for
more details.
• Press CANCEL to exit redial, directory or
caller ID log when you are on a call.
Find handset
Use this feature to find the system
handset.
To start paging:
• Press /FIND HANDSET on the
telephone base when not in use.
All idle handsets ring and display
** Paging **.
To end paging:
• Press /FIND HANDSET at the
telephone base.
-OR-
• Press or any of the dialing keys on
the handset.
NOTES
• Press MUTE to turn off the ringer of
a handset temporarily. Paging tone
continues on the other handset.
• Do not press and hold /FIND HANDSET
for more than four seconds. It may lead
to handset deregistration. If the handset
displays To register HS and See manual,
refer to the Register a handset section to
register the handset back to the telephone
base.
Redial list
Each handset stores the last five
telephone numbers dialed. Entries are
shown in reverse chronological order.
When there are already five entries, the
oldest entry is deleted to make room for
the new entry.
Review a redial list entry
1. Press REDIAL when the handset is
not in use.
2. Press q, p or REDIAL repeatedly
until the desired entry displays.
Dial a redial list entry
1. Press REDIAL when the handset is
not in use.
2. Press q, p or REDIAL repeatedly
until the desired entry displays.
3. Press to dial.
-OR-
1. Press when the handset is not in
use.
2. Press REDIAL and then press q,
p or REDIAL repeatedly until the
desired entry displays.
3. Press SELECT to dial.
Delete a redial list entry
1. Press REDIAL when the handset is
not in use.
2. Press q, p or REDIAL repeatedly to
browse to the desired entry.
3. Press DELETE to delete the
displayed number. You hear a
confirmation tone.
To Next Page
Loading...
Need help?
General
