VTech CS6114 A

2
Use only the power adapter(s) and battery(ies) supplied with this product.
To order a replacement, visit our website at www.vtechcanada.com or
call 1 (800) 267-7377.
The power adapters are intended to be correctly oriented in a vertical
or floor mount position. The prongs are not designed to hold the plug in
place if it is plugged into a ceiling, under-the-table or cabinet outlet.
If you subscribe to telephone service from a cable company or a VoIP
service provider, plug the telephone line cord into the modem/router/
terminal adapter provided by your cable/VoIP service provider. Contact
your cable/VoIP service provider if you have any difficulties in installation.
•
•
•
Telephone base and charger installation
Install the telephone base and charger as shown below.
Telephone base
Telephone
line cord
Electrical outlet
(not controlled
by a wall switch)
Telephone
wall jack
DSL filter (not
included) is
required if you have
DSL high-speed
Internet service
Telephone base
power adapter
Wall mounting (optional)
Your telephone comes ready for tabletop use.
To mount your telephone on the wall:
Position the top hole at the back of the telephone base against the top
mounting stud [A].
Slide the telephone base down on the mounting
studs [A] and [B] until it locks into place.
1.
2.
Telephone base
[A]
[B]
Mounting
studs
Charger
Charger
adapter