VTech CS6114 A User Manual

6
Make a call
Press
/FLASH and then dial the telephone number.
Answer a call
Press
/FLASH or any of the dialing keys (0-9, TONE
or #).
End a call
Press OFF/
CANCEL or put the handset to the telephone base or charger.
Volume
During a call, press
CID/VOL
-
or /VOL
+
to
adjust the listening volume.
Mute
The mute function allows you to hear the other party but the other party
cannot hear you.
During a call, press MUTE/
DELETE. The screen
displays Muted until the mute function is turned off.
Press MUTE/
DELETE again to resume the
conversation. The screen temporarily displays
Microphone on.
Share an outside call (for models CS6114-2/CS6114-2 A/CS6114-21/
CS6114-21A only)
You can use both handsets at a time on an outside call.
When a handset is already on a call, press
/FLASH on another
handset to join the call.
To exit the call, press OFF/
CANCEL or place the handset in the telephone
base or charger. The call continues until all handsets hang up.
Call waiting
When you subscribe to call waiting service from your telephone service
provider, you hear an alert tone if there is an incoming call while you are on
another call.
Press
/FLASH to put the current call on hold and take the new call.
Press
/FLASH at any time to switch back and forth between calls.
Temporary ringer silencing
When the telephone is ringing, you can temporarily silence the ringer of the
handset without disconnecting the call. The next call rings normally at the
preset volume.
To silence the handset ringer, press OFF/
CANCEL or
MUTE/
DELETE and Ringer muted displays.
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to tone
dialing temporarily during a call. This is useful if you need to send touch-
tone signals to access your telephone banking or long distance services.
During a call, press
TONE .
Use the dialing keys to enter the relevant number. The telephone sends
touch-tone signals.
The telephone automatically returns to pulse dialing mode after you end
the call.
Redial
The telephone stores the five most recently dialed numbers. When there
are already five entries, the oldest entry is deleted to make room for the
new entry.
To review and dial a number from the redial list:
Press REDIAL/
PAUSE when the handset is not in use.
Press
CID, or REDIAL/PAUSE repeatedly until the
desired entry displays.
Press
/FLASH to dial.
To delete a redial entry:
When the desired redial entry displays, press
MUTE/DELETE.
•
•
•
•
1.
2.
•
•
•
•
•
1.
2.
3.
1.
2.
3.
Telephone operation
CANCEL
Ringer muted
10:15
PM 12/25

VTech CS6114 A Specifications

Frequency

Transmit frequency (Handset)	1921.536-1928.448 MHz
Transmit frequency (Telephone base)	1921.536-1928.448 MHz
Channels	5

Power Requirements

Handset battery voltage	2.4V Ni-MH
Telephone base power	6V AC @ 300mA
Charger power	6V AC @ 300 mA

Memory

Handset directory memory locations	30
Handset directory digits	up to 30 digits
Handset directory characters	up to 15 characters