VTech CS6114 Online User's Manual

3
Getting started
4
Battery installation
After you install the handset battery, the handset will prompt you to set the
date and time. The handset will also prompt you to set the date and time
after a power failure. For instructions, see Set date and time on page 9. To
skip, press OFF/CANCEL.
Install the battery as shown below.
Plug the battery connector securely into the socket inside the handset
battery compartment.
Place the battery with the label THIS SIDE UP facing up and the wires
inside the battery compartment.
Align the cover at against the battery compartment, then slide it
towards the center of the handset until it clicks into place.
Charge the handset by placing it in the telephone base. The
CHARGE light remains on whenever the handset is charging in the
telephone base.
1.
2.
3.
4.
If the handset will not be used for a long period of time, disconnect and
remove the battery to prevent any possible leakage.
To purchase a replacement battery, visit our website at
www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to
www.vtechcanada.com or call 1 (800) 267-7377.
•
•
3
CANCEL
CHARGE
light
2
1

VTech CS6114 Specifications

Frequency

transmit frequency handset	1921.536-1928.448 MHz
transmit frequency telephone base	1921.536-1928.448 MHz

Power

power requirements handset	2.4V 400mAh Ni-MH battery
power requirements telephone base	6V AC @ 300mA
power requirements charger	6V AC @ 300 mA

Memory

handset directory	30 memory locations; up to 30 digits and 15 characters
handset call log	30 memory locations; up to 24 digits and 15 characters

Weight and Dimensions

size handset	6.50 X 2.0 X 1.26 in (165.0 X 51.0 X 32.0 mm)
size telephone base	3.55 X 3.44 X 4.67 in (90.2 X 87.5 X 118.5 mm)
size charger	2.91 X 3.19 X 1.85 in (74.0 X 81.0 X 47.0 mm)
weight handset	4.59oz (130.0g)
weight telephone base	4.32oz (122.6g)
weight charger	1.76oz (50.0g)