VTech CS6419-2 User Manual

6
Call waiting
When you subscribe to call waiting service from your telephone service
provider, you hear an alert tone if there is an incoming call while you are on
another call.
Press /FLASH to put the current call on hold and take the new call.
Press /FLASH at any time to switch back and forth between calls.
Temporary ringer silencing
When the telephone is ringing, you can temporarily silence the ringer of the
handset without disconnecting the call. The next call rings normally at the
preset volume.
To silence the handset ringer, press OFF/CANCEL or MUTE/DELETE on
the handset. RINGER MUTED and display.
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to tone
dialing temporarily during a call.
During a call, press TONE .
Use the dialing keys to enter the relevant number. The telephone sends
touch-tone signals.
The telephone automatically returns to pulse dialing mode after you end
the call.
Find handset
Use this feature to nd all system handsets.
To start paging:
Press /FIND HANDSET on the telephone base once and then release.
All idle handsets ring and their screens show ** PAGING **.
To end paging:
Press /FIND HANDSET on the telephone base once and then release.
Press /FLASH, or any dialing key (0-9, TONE or #) on the handset.
Place the handset in the telephone base or charger.
Redial list
Each handset stores the last 10 telephone numbers dialed.
To review and dial a number from the redial list:
Press REDIAL/PAUSE when the handset is not in use.
Press , , oror REDIAL/PAUSE repeatedly until the desired entry displays.
Press /FLASH to dial.
To delete a redial entry:
When the desired redial entry displays, press MUTE/DELETE.
Chain dialing
Use this feature to initiate a dialing sequence from numbers stored in the
directory, call log or redial list while you are on a call. Chain dialing can
be useful if you wish to access other numbers (such as bank account
numbers or access codes) from the directory, call log or redial list.
To access a number in the directory, call log or redial list while on a call:
To enter the directory, press MENU/SELECT and scroll to >DIRECTORY,
then press MENU/SELECT.
-OR-
To enter the call log, press MENU/SELECT and scroll to >CALL LOG,
then press MENU/SELECT.
-OR-
To enter the redial list, press REDIAL/PAUSE.
Press or to scroll to the desired entry.
Press MENU/SELECT to dial the displayed number.
•
•
•
1.
2.
3.
•
•
•
•
1.
2.
3.
1.
2.
3.
Do not press and hold /FIND HANDSET for more than four seconds. It may
lead to handset deregistration. If 1.PRESS FIND HS ON BASE 4 SEC and
2.THEN PRESS # ON HANDSET display alternately on the handset, refer to
Troubleshooting to register the handset to the telephone base.

VTech CS6419-2 Specifications

Transmit Frequency

handset transmit frequency	1921.536-1928.448 MHz
telephone base transmit frequency	1921.536-1928.448 MHz

Power Requirements

handset battery voltage	2.4 V
telephone base power	6 V AC @ 300 mA
charger power	6 V AC @ 300 mA

Memory

handset directory memory locations	50
handset directory digits	30 digits
handset directory characters	15 characters