VTech CS6429-2 User Manual

46
Remote access
A two-digit security code is required to access the answering system remotely
from any touch-tone telephone. The preset code is 19; see Remote access
code on page 37 to change it.
To remotely access the answering system:
Dial your telephone number from any touch-tone telephone.
When the answering system answers, enter the two-digit remote access code.
Then you can enter one of the following remote commands.
1.
2.
3.
Command Function
1
Play all messages.
2
Play new messages.
3
Delete a message (during playback).
33
Delete all old messages.
4
Repeat the current message (during playback).
5
Stop.
*5
Hear a list of remote commands.
6
Skip to the next message (during playback).
*7
Record an announcement.
8
End the call.
0
Turn the answering system on or off.
Hang up or press 8 to end the call.4.
Answering system operation
If you do not press any keys after you enter the remote access code, all new
messages play. If there are no new messages, all old messages play.
Once the new messages have played, the telephone announces the help
menu options. If you do not press any key within 20 seconds, the remote
access call automatically disconnects.
When the answering system is turned off, the telephone answers after 10
rings, and announces, “Please enter your remote access code.”
•
•
•

VTech CS6429-2 Specifications

Frequency and Channels

transmit frequency handset	1921.536-1928.448 MHz
transmit frequency telephone base	1921.536-1928.448 MHz
channels	5

Power Requirements

handset battery	2.4V Ni-MH battery
telephone base power	6V DC @ 400mA
charger power	6V AC @ 300mA

Memory

handset directory memory locations	50 memory locations
handset directory digits capacity	up to 30 digits
handset directory characters capacity	15 characters