VTech CS6429-2 User Manual

51
Expand your telephone system
The handsets provided with your telephone system are already registered. Each
handset is assigned a number that show on the handset display. Additional
handsets registered to the telephone system are assigned in sequential order.
For instance, if the telephone system already has HANDSET 1 and
HANDSET 2, the new registered handset is assigned HANDSET 3. This
telephone system accommodates up to five handsets.
Add and register a handset (optional)
You can add new handsets (CS6409, purchased separately) to your telephone
system. Each handset must be registered with the telephone base before use.
When first purchased, each expansion handset shows 1.PRESS FIND HS ON
BASE 4 SEC and 2.THEN PRESS # ON HANDSET alternately. You may need
to charge the handset before registering to the telephone base. For more details
on battery charging, see the table on page 4.
To register a handset:
Place the unregistered handset in the telephone base or charger. If
1.PRESS FIND HS ON BASE 4 SEC and 2.THEN PRESS # ON HANDSET
do not appear alternately on the handset screen after a few seconds, remove
the handset and place it in the telephone base or charger again.
On the telephone base, press and hold /FIND HANDSET
for about four seconds until the red IN USE light on the
telephone base turns on.
On the handset, press # (pound key) and the handset
shows REGISTERING..... PLEASE WAIT. The handset
shows HANDSET REGISTERED and you hear a beep
when the registration process completes. It takes about
60 seconds to complete.
1.
2.
3.
Appendix
If the registration fails, the handset shows REGISTRATION FAILED and
then 1.PRESS FIND HS ON BASE 4 SEC and 2.THEN PRESS # ON
HANDSET alternately. Remove the handset from the telephone base and
place it back in. Try the registration process again.
You cannot register a handset if any other system handset is in use.
To reset the telephone, unplug the power and the battery for a few seconds
then plug them back in.
Only one handset can register to the telephone base at a time.
•
•
•
•

VTech CS6429-2 Specifications

Frequency and Channels

transmit frequency handset	1921.536-1928.448 MHz
transmit frequency telephone base	1921.536-1928.448 MHz
channels	5

Power Requirements

handset battery	2.4V Ni-MH battery
telephone base power	6V DC @ 400mA
charger power	6V AC @ 300mA

Memory

handset directory memory locations	50 memory locations
handset directory digits capacity	up to 30 digits
handset directory characters capacity	15 characters