VTech CS6429-2 User Manual

48
NUMBER ALREADY SAVED
The telephone number you have entered is already stored
in the directory.
NEW VOICEMAIL
There are new voicemail messages from your telephone
service provider.
NO BATTERY
You place the handset in the telephone base or charger
without installing a battery in that handset.
NO LINE
There is no telephone line connected.
NO MESSAGE
There are no messages in the answering system.
NO SIGNAL,
CALL ENDED
Communication between the handset and the telephone
base is lost during a call.
NOT AVAILABLE
AT THIS TIME
Someone else is already using the directory, speed dial list,
call log or answering system.
OUT OF RANGE OR
NO PWR AT BASE
The handset has lost communication with the
telephone base.
**PAGING**
The telephone base is paging all handsets.
PHONE
The handset is on a call.
PLACE IN CHARGER
The battery is very low. The handset should be placed in
the telephone base or charger for charging.
REC MEM FULL
The answering system memory is full.
REC MEM LOW
The answering system has less than three minutes of
recording time left.
RINGER MUTED
The ringer is muted temporarily during an incoming call.
SAVED
The entry has been saved in the directory.
SPEAKER
The handset speakerphone is in use.
UNABLE TO CALL.
TRY AGAIN
Failed intercom or two handsets are already on a call.
XX MISSED CALLS
There are XX new calls in the caller ID history.
XX NEW MESSAGES
There are XX new messages in the answering system.
Handset display screen messages
Appendix

VTech CS6429-2 Specifications

Frequency and Channels

transmit frequency handset	1921.536-1928.448 MHz
transmit frequency telephone base	1921.536-1928.448 MHz
channels	5

Power Requirements

handset battery	2.4V Ni-MH battery
telephone base power	6V DC @ 400mA
charger power	6V AC @ 300mA

Memory

handset directory memory locations	50 memory locations
handset directory digits capacity	up to 30 digits
handset directory characters capacity	15 characters