EN - 24
Question Suggestions
9. The cordless handset beeps and is not
performing normally.
• Make sure the Cat-5 network cable is
plugged into the NET port of the
base station and the network wall jack
with Power over Ethernet (PoE).
• Check your SIP server or telephone
administrative settings. Refer to the SIP
Phone Configuration Guide for details.
• Disconnect the base station from the
network wall jack and connect a different
working SIP telephone. If the other SIP
telephone has the same problem, the
problem is in the wiring or network server.
Contact your telephone service provider
(charges may apply).
• Other electronic products such as HAM
radios and other DECT phones can cause
interference with your cordless phone.
Try installing your phone as far away as
possible from these types of electronic
devices.
10. There is interference during a telephone
conversation, or the call fades in and out
when I am using the cordless handset.
• The cordless handset may be out of range.
Move the handset closer to the base station
or adjust the setting of RF transmission
power. Refer SIP Phone Configuration
Guide for details.
• Other electronic products such as HAM
radios and other DECT phones can cause
interference with your cordless phone.
Try installing your phone as far away as
possible from these types of electronic
devices.
• If other SIP telephones in your hotel are
having the same problem, the problem is
in the wiring or network server. Contact
your telephone service provider (charges
may apply).
To Next Page
Loading...
