VTech DigiArt - Getting Started; Battery Installation Guide

10
GETTING STARTED
Step 2:
Unsnap A2, lift the CHALKBOARD/DRY-ERASE BOARD (A) with one
hand and move the back legs forward with the other hand. Insert A2 into
the slot on the back of the SUPPLIES TRAY (B), lining up the hole of A2
with the center screw of the SUPPLIES TRAY (B).
Step 3:
Tightenthecenterscrewbypushingitinandturningitclockwisetox
it in position.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery compartment on the
bottomofthechalkboard.Openthebattery
cover by sliding the tab.
3. Remove the exhausted batteries and install
4 new “AA” batteries as illustrated.
4. Replace the battery cover and push down
until it clicks into position.