Step 3:
Snap A2 into place and tighten the center screw by pushing it in and
turning it clockwise to x it in position. Then tighten the left and right
screws on the SUPPLIES TRAY (B) by turning them clockwise. The
DRAWING TABLE is now ready to use and the LED SCREEN AREA
will rotate automatically.
TRANSfORm fROm DRAWING TABLE
TO EASEL
Step 1:
Make sure the unit is turned OFF before transforming. Loosen the
left and right screws on the SUPPLIES TRAY (B) by turning them
counterclockwise. Then, loosen the center screw by pushing in and
turning it counterclockwise.
TRANSfORmATION INSTRUCTIONS
To Next Page
Loading...
