VTech DM221 User Manual

23
Appendix
Troubleshooting
Other electronic products such as HAM radios and cordless phones
can cause interference with your baby monitor. Try installing your baby
monitor as far away as possible from these types of electronic devices.
Completely remove and install the battery again. Turn on the baby unit
and the parent unit
. Allow up to one minute for the parent unit and the
baby unit to synchronize.
My parent unit beeps and is not performing normally.
Move the parent unit closer to the baby unit (but not less than 3 feet).(but not less than 3 feet)..
The parent unit may be out of range.
If the parent unit is operated with battery alone, it may be running out of
battery. Charge the battery in the parent unit for up to 11 hours.
Reset the baby unit by unplugging the electrical power to the baby unit.
Wait for 15 seconds and plug it back in again. Turn on the baby unit and
the parent unit. Allow up to one minute for the parent unit and the baby
unit to synchronize.
Other electronic products such as HAM radios and cordless phones
can cause interference with your baby monitor. Try installing your baby
monitor as far away as possible from these types of electronic devices.
The link between the baby unit and the parent unit is
lost every now and then, and I’m experiencing sound
interruptions.
Move the parent unit closer to the baby unit (but not less than 3 feet).
The parent unit may be out of range.
Reset the baby unit by unplugging the electrical power to the baby unit.
Wait for 15 seconds and plug it back in again. Turn on the baby unit and
the parent unit. Allow up to one minute for the parent unit and the baby
unit to synchronize.
Common cure for electronic equipment.
If the baby monitor is not responding normally, try the following (in the
order listed):
- Disconnect the power to the baby unit and the parent unit.
- Completely remove and install the battery again.
- Wait a few minutes before connecting power back to the baby unit
and the parent unit.
- Charge the parent unit battery for up to 11 hours.
- Wait for the parent unit to synchronize with the baby unit. Allow up
to one minute for this to take place.
•
•
•
•
•
•
•
•
•

VTech DM221 Specifications

General

Brand	VTech
Model	DM221
Category	Baby Monitor
Language	English