VTech InnoTab 2 - Getting Started; Battery Installation

4
Wrist Strap Fastener If you wish, attach a wrist strap here. (NOTE:
Wrist strap not included.)
Slide this switch to open the battery door.
Always replace the InnoTab
®
2 battery door
after changing batteries.
SD Card Slot Insert an SD memory card (not included).
(NOTE: InnoTab
®
2 is compatible with SD and
SDHC memory cards up to 32GB.)
Battery Compartment Insert 4 AA batteries (not included). For
battery installation instructions, please see
the next section.
Stand Pull out this stand to prop up InnoTab
®
2 and
use it as a digital photo frame.
Battery Installation
•Makesurethetabletisturnedoff.
•Locatethebatterydoorlockslidingswitchonthe
back of the tablet. Slide the switch to open the
battery door, then remove the door.
•Insert4AAbatteriesasshowninimage2.
•Makesuretoreplacethebatterycover.
Battery Notice
•Useonlybatteriesofthesameorequivalenttype
as recommended.
•Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-zinc)
or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
•Donotusedamagedbatteries.
•Insertbatterieswiththecorrectpolarity.
•Donotshort-circuitthebatteryterminals.
•Removeexhaustedbatteriesfromthetoy.
•Removebatteriesduringlongperiodsofnon-use.
•Donotdisposeofbatteriesinfire.
2
1
G
E
T
T
i
N
G
S
T
a
r
T
E
d
Battery Door Lock Sliding
Switch