14
Basic Operation
Handset Operation
Call Forward
• A Handset (HS1) on an external call can
forward it to the other Handset (HS2) by
pressing and holding the INT key. The
display of HS1 will initially show:
• HS2 can press ON to answer the call.
NOTE: If HS2 does not answer the call in about
30 seconds, the external call will be returned to
HS1 and the display will show:
If the returned call is not answered within another 30
seconds, the external call will end automatically.
Call Transfer
• A Handset (HS1) on an external call can forward it to the other Handset (HS2)
by pressing the INT key.
NOTE: The external call is put on hold automatically.
• HS2 will ring, showing an intercom call.
• HS2 can answer the intercom call by pressing ON.
• Intercom call link is established while the external call is still on hold. HS1
may discuss the external call with HS2.
• When HS1 presses OFF, the external call is then transferred to HS2. CALL
TRANSFERRED will display on HS1 briefly.
NOTE: If there is no answer on HS2, HS1 can reconnect to the held call by
pressing ON.
Conference Call
It is possible to establish a conference between
two Handsets and the external line.
If a Handset already has a connection to the
external line, the other Handset can join the call by
pressing ON, a conference will be immediately
established. Both Handsets will show:
Base Operation
From the Base Unit, you can use PAGE key to
locate the Handsets for 60 seconds.
• When the Handset is in idle, press PAGE. The
Handsets will display:
• To end the page at the Base, press PAGE
again.
• To end the page at the Handset, press ON,
SPEAKER or any dialing keys.
To Next Page
Loading...
Need help?
General
