61
MENU/SELECT to confirm, the
current paired headset will be
automatically removed, regardless
of whether the pairing of the new
device is successful or not.
4. Set your headset to discoverable
mode (refer to the user’s manual of
your headset). The screen displays
Adding Headset Y when the base is
connecting to your headset (Headset
Y represents the device name of your
Bluetooth headset).
5. Once your cell phone finds your
VTech phone (VTech DECT 6.0),
press the appropriate key on your
cell phone to continue the pairing
process.
6. When the headset successfully
connects to the telephone, the
telephone screen displays Headset
added, and the corresponding
status icon ( 1 or 2) displays.
The corresponding device light
on the telephone base (CELL 1 or
CELL 2/HEADSET) turns on.
NOTES
• The pairing process may take up to
one minute. If the pairing process
fails, try again.
• When a connected headset is
charging, it may disconnect from
the telephone base and the
CELL 2/HEADSET light on the
telephone base turns off. For some
headset models, you may need to
turn on the headset and reconnect it
to the telephone base again.
Auto connection
When an active device moves within
Bluetooth range of the telephone base,
or is turned on within range, the
telephone base tries to connect to the
device. When the device moves out of
range, it is disconnected. Your device
might make a connect or disconnect
sound.
A connected device could also be
disconnected by:
• Turning off the Bluetooth device.
• Turning off the Bluetooth feature of
the device.
• Disconnecting through the
telephone base Device list. If you
disconnect through the Device list,
the telephone base will not attempt
to reconnect until your device is
moved out of range and then moves
back in range again.
To Next Page
Loading...
Need help?
General
