VTech Kidi DJ Drums - Battery Removal and Installation

6
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on
the bottom of the unit. Use a
screwdriver to loosen the screw
and then open the battery cover.
3. If used batteries are present,
remove these batteries from the
unit by pulling up on one end of
each battery.
4. Install 4 new AA (LR6/AM-3)
batteries, following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and
tighten the screw to secure.