Inserting the Camera Into the Waterproof Case
• Make sure the Wrist Strap is not attached to the camera to avoid a
water leak and damage to the camera.
• Inspect the O-Ring for water leaks before inserting the camera into the
case. Refer to the later section for details about inspecting the O-Ring.
• Rotate the camera lens to the direction in which you would like to use
it before inserting the camera into the Waterproof Case.
• Open the case cover by pulling the Buckle Handle outwards as
indicated by the arrow icon below. After the handle is loosened, the
buckle can be opened.
• Once the Waterproof Case is open, insert the camera, taking note of
the position of the buttons. As a point of reference, the Memory Card
Slot will be on the same side as the buckle on the Waterproof Case.
• Close the case cover and the buckle to hold the cover in position.
Push the Buckle Handle towards the case body to tighten the buckle.
• The camera is now ready for underwater use up to 6 feet.
To Next Page
Loading...
