4. Firmly apply pressure to the Adhesive Flat Mount and the contact
surface, making sure that the surface makes contact over the entire
area.
5. It is recommended that the Adhesive Flat Mount stay on the surface
at room temperature for 1 day before use to allow the maximum
strength to be achieved. At room temperature, approximately 50% of
the ultimate strength will be achieved after 20 minutes, 90% after 24
hours and 100% after 72 hours.
6. Align the Tripod Screw Hole on the camera to the screw of the
Adhesive Flat Mount. Tighten the screw on the Adhesive Flat
Mount clockwise to afx the camera on the mount.
7. Loosen the Angle Adjustment Handle and you can rotate the Angle
Adjustment Arm to adjust the capture angle.
8. Tighten the Angle Adjustment Handle after you set the capture angle.
Note: Once the adhesive surface is stuck and afxed to a device,
do not tear it off. Otherwise, the adhesive performance may be
reduced and it may not work well for subsequent use. The mount can
be detached from the adhesive part. Push the detachable buckle as
shown in the illustration below to separate the two parts.
Caution: Do not adjust the bicycle mount / adhesive mount while riding.
To Next Page
Loading...
Need help?
General
