will not charge. Only move the switch to the Off position when the watch
will not be used for an extended period of time.
Note: It is not necessary to turn the watch off in daily use. Once the
Master Power Switch is Off, the watch will stop functioning. After it is
turned On again, the time and date will have to be reset.
BATTERY RECHARGING
Note: Adult operation required.
The watch should be fully charged before rst use. To charge the My
First Kidi™ Smartwatch, connect the watch to a computer using the
included Micro-USB Cable. To do so correctly, please follow these
steps:
• Make sure that the Master Power Switch is set to the On position
before charging.
• Pull up the rubber cover of the Micro-USB Port on the side of the
watch.
• Insert the Micro-USB Cable (small end) into the Micro-USB Port on
the watch.
• Insert the large end of the Micro-USB Cable into a USB port on your
computer.
• Once the connection is successful, you will see a battery charging
symbol appear on the watch screen.
• Check the charging progress regularly throughout recharging.
• When the battery is fully charged, the fully charged
battery icon will appear. Then the screen will
automatically turn off. You may then disconnect
your fully charged watch from the computer.
Note: It will take approximately 3.5 hours to fully
charge the battery. The actual charging time
depends on the charging current, the remaining charge in the battery
prior to recharging, and the ambient temperature. The optimum ambient
temperature is 32°F - 104°F (0°C to 40°C)
To Next Page
Loading...
Need help?
General