VTech SN5127

80
Answering system
Remote access
You can reach your answering system remotely by dialing your home telephone number
from any touch-tone telephone. A two-digit security code is required. The preset code is 19.
You can set the code from 00 to 99.
To access your answering
system remotely, dial your
telephone number from
any touch-tone telephone.
1
When the system plays
your answering system
announcement, “Hello.
Please leave a message
after the tone.“, enter the
two-digit security code.
2
Enter one of the remote
commands.
3
Command Description
1
Play all messages.
2
Play only new messages.
3
Delete the current message (during playback).
33
Delete all old messages.
4
Repeat the current message (during playback).
5
Stop.
*5
Hear a list of remote commands.
6
Skip to the next message (during playback).
*7
Record a new announcement.
8
End the call.
0
Turn the answering system on or off.