Caution
How to take out the battery for disposal
Note: The below steps must be carried out by an
adult and with care.
1. Ensure that the MASTER POWER SWITCH is
set to the OFF
position.
2. Loosen the four screws on the back of the watch
using a cross head screwdriver, then remove the
back.
3. Locate the positive red
wire and the negative
black wire that connect
the battery to the watch.
Wearing protective gloves is suggested in case any battery leakage has
occurred.
4. Pull out the battery pack until both the positive and negative wires are
detached from the product.
Note: Do not cut the wires simultaneously with scissors, pointed objects
or any other electrical conductors.
5. After the battery has been taken out, make sure it is handled carefully
and disposed of properly.
Important note:
• Donotpiercethebatterypackwithanysharpobjects.
• Donotallowanywiresleftattachedtothebatterytotoucheachother.
• Do not touch ends of wires attached to the battery with any other
electrical conductors.
• Donotexposethebatterytodirectsunlightorhightemperatures.
• DonothandleadamagedLi-ionpolymerbattery.
Positive wire
Battery pack
Negative wire
CAUTION