1. Press MENU until you hear “Record outgoing message.”
2. Press REC/MEMO. After you hear “Now recording” followed by a beep, speak toward the
base to record an announcement up to 90 seconds long.
3. Press PLAY/STOP. The system plays back your recorded message.
To review your announcement at any time:
1. Press MENU until you hear “Record outgoing message.”
2. Press PLAY/STOP. The system plays the current announcement.
To delete your announcement:
Press DELETE during announcement playback. The system will use the pre-recorded announcement
until you record a new one.
Setting Up Your Answering System
You can set up one feature at a time, or you can set up a feature and then move on to set up the other
features in sequence.
1. Press MENU until the system announces the feature you want to set. Refer to the Feature
Summary on the following page for a description of the features and your choices.
2. Press CHANGE until the system announces the desired setting.
3. Press TIME/SET to conrm your selection.
4. Press MENU to move on to the next feature, or press PLAY/STOP button to exit feature
setup.
Feature Summary
Answering System Operation At The Base
• Announcements
less than three
seconds will not
be saved.
To Next Page
Loading...
