System Announces: Description/Directions
“Set security code”
19*
Use CHANGE to choose the remote access
code you will use to access features and
functions of the answering system from a touch
tone phone. You can select any 2-digit code,
from 10 to 99.
“Set audible message alert”
Off *
On
When message alert is turned on, the base
beeps once every 10 seconds when new
messages have been received.
“Set announce only”
Off*
On
When you turn announce only ON, callers hear
your announcement, but cannot leave
a message.
“Set base ringer”
On*
Off
Turn the base ringer on or off.
“Set number of rings”
2
4 *
6
Choose how many times the phone will ring
before the system answers a call.
Toll Saver With toll saver active, the system answers after
two rings when you have new messages and
after four when you have no new messages.
Listen to & Delete Messages
Answering System Operation At The Base
• To advance the
remote access
code by 10, press
and hold SELECT.
• Feature summary
options listed with
an * are your
phones default
setting.
To Next Page
Loading...
