VTech VCS754 - Page 101

Configuration File Parameter Guide 101 Back to Contents
VCS754 Administrator and Provisioning Manual
Setting: provisioning.resync_time
Description: Sets the interval (in minutes) between checks for new firmware and/or
configuration files.
Values: 0–65535 Default: 0 (OFF)
Setting:
provisioning.remote_check_sync_enable
Description: Enables or disables remotely triggering the device to check for new firmware
and/or configuration files. The file checking is triggered remotely via a SIP
Notify message from the server containing the
check-sync event.
Values: 0 (disabled), 1 (enabled) Default: 1
Setting:
provisioning.crypto_enable
Description: Enables or disables encryption check for the configuration file(s). Enable
if you have encrypted the configuration file(s) using AES encryption.
Values: 0 (disabled), 1 (enabled) Default: 0
Setting:
provisioning.crypto_passphrase
Description: Sets the AES encryption passphrase for decrypting the configuration
file(s). Enter the key that was generated when you encrypted the file.
Values: Text string Default: Blank
Setting:
provisioning.check_trusted_certificate
Description: Enables or disables accepting only a trusted TLS certificate for access to
the provisioning server.
Values: 0 (disabled), 1 (enabled) Default: 0
Setting:
provisioning.pnp_enable
Description: Enables or disables the VCS754 checking for the provisioning URL using
the Plug-and-Play Subscribe and Notify protocol.
Values: 0 (disabled), 1 (enabled) Default: 1
Setting:
provisioning.pnp_response_timeout
Description: Sets how long the VCS754 repeats the SUBSCRIBE request if there is
no reply from the PnP server.
Values: 1–60 Default: 10