quiet mode is on.
Answering system settings
Set your built-in answering system
The answering system can record and store up to 99 messages. Each message can be up to three minutes in
length. The total storage capacity for the announcement, messages and memos is approximately 22 minutes. The
actual recording time depends on individual message characteristics.
Your answering system allows you to set your announcement, to save and delete messages, activate call
screening, to set number of rings before pick up, and to access remotely.
Voice guide to set up answering system
This feature is an alternative way for you to do the basic setup of the answering system. You can follow the voice
guide to record your own announcement, set the number of rings, and set the message alert tone.
To use the voice guide feature:
1. Press MENU/SELECT on the telephone base in idle mode.
2. Press ▼ CID or ▲ to scroll to Answering sys, then press MENU/SELECT.
3. Press ▼ CID or ▲ to scroll to Voice guide, then press MENU/SELECT. You hear a voice prompt, “This voice
guide will assist you with the basic setup of your answering system.“
4. Set up your answering system by inputting designated numbers, as instructed in the voice guide.
NOTES
You can press CANCEL on the telephone base to quit the voice guide at any time.
After a power outage, the telephone base prompts you to set the date and time, and Smart call blocker. After
these settings are done or skipped, the telephone base then prompts if you want to set up the answering
system via voice guide. Press MENU/SELECT to start the setup.
Message playback settings
If you have new messages, the telephone plays only the new messages (oldest first). If there are no new
messages, the telephone plays back all messages (oldest first).
When playback begins, you hear the total number of messages followed by the date and time of the message.
After the last message, the telephone announces, “End of messages.”
NOTE
Make sure you Set date and time correctly.
Set remote access code
You can set your own remote access code from 00 to 99.
To change the remote access code:
Using a cordless handset or telephone base:
To Next Page
Loading...
