7. Use of Display Panel
Use Instructions
If the display panel gives out any unusual noise, smoke or smell, plug off the
power connector immediately, and turn to the qualified technician for help.
Plug off the power connector in case of thunder storm or when the display panel
will be idle for a long time.
Check the power cable regularly to see if its insulation is intact and the contact
gets overheated.
In the following situations, please plug off the power connector and turn to the
qualified technicians:
The power connector or power cable is damaged or worn out;
Liquid drops into the display panel;
The display panel falls down to the floor or the enclosure is damaged;
The display panel has obvious functional exception or performance change;
The LCD is a fragile product made of glass. Any falling, striking or strong
vibration will cause the breakage of the glass. It is prohibited to forcefully press
the display zone of the LCD, or squeeze the LCD screen and frame during the
installation. You should pay attention to the overall evenness of the LCD and
avoid any bending or distortion caused by external force. Do not scratch the
display zone with hard objects.
The LCD may become crystallized when operating or stored in the temperature
and humidity range below the specifications, and this damage is unrecoverable. If
it is operated or stored in the temperature and humidity range above the
specifications, the crystal may turn into the isotropous liquid, and this damage is
also unrecoverable. Please store and use this display panel within the allowable
temperature and humidity range.
To Next Page
Loading...