7.1 System Startup/Shutdown
Startup sequence:
1. Check if the main power supply for the whole display wall system is ON.
2. Check if the power switch on the LCD display panel back plate is ON.
3. Start the control PC and run the control software (if the system requires the use
of the control software).
4. Start all the display panels via the control software or by pressing the system
switch on the interface board.
Shutdown:
Shut down all the display panels via the control software interface or by pressing
the system switch on the interface board.
Note:
When you select to shut down the display panel in the control software interface,
this operation only switches the display panel to standby state, and the power
supply of the display panel has not been shut down. You need to use the power
switch on the rear panel to completely shut down the power supply of the display
panel. When the display panels are in standby state, you can start all the display
panels again in the control software interface.
To Next Page
Loading...